Node Submission Form

You must meet these quirements in order to get your node added into this data base
Please complete this check list for your node:

My node...
  • is an RF node for Echolink.
  • operates at least 18 hours a day 7 days a week. (USA only requirement)
  • will be operational long term.
  • is not arbitrarily closed to remote incoming -L connections.
  • is not arbitrarily closed to remote incoming -R connections.
  • is not arbitrarily closed to other countries.
  • is not arbitrarily closed to incoming personal computer users.
  • is open for RF access usage either DTMF or SysOp assisted.

Does your node meet all the above requirements?

* = Required

*First and Last Name:

*Your Email Adress:

Node Information

*Node Number:

*Node Callsign (include the -L or -R):

Website:

(Use the closest city your node's transmitter is near)
*City: *State:

*Country:

Node Frequency Information

-If you run a link to a repeater, submit the repeater's output frequency
otherwise, submit the simplex frequency.

*Frequency:

*Offset: If you selected other:

*Pl Tone:

When selecing your node's coverage, base it on what
coverage a mobile station would get.

*Coverage:

Location Information

No guessing please. Leave blank if you do not know.
If you operate on or through a repeater, use coordianates of the repeater's location.
Only use coordinates of the link radio if it is simplex.

Latitude: Deg. Min. Sec.

Longitude: Deg. Min. Sec.

DTMF Access Information

*Do you allow for DTMF access of your node:
(If you answer 'Yes', you need to include any DTMF codes below that may be used or required.)

UpLink:
(Only enter the UpLink code if it is required for a station to use
to turn on your link first prior to using.)

DownLink:
(Only enter the DownLink code if it is required for a station to use
to turn off your link after its use.)

Connect:
(The Connect code by default is simply a station entering in a node number. This is
not where you put your node number but rather the letter or number that is required
to be entered first to connect to another node such as 'A' or some other character, enter that here if required.)

Disconnect:
(Default is the # key. Some stations require ## or *# depending on there repeater's setup.)

LinkStatus:
(The LinkStatus code is used to check the status of a link. Default is 08)

PlayInfo:
(The PlayInfo is use to quickly check if a link is on and in range, or to receive brief
intructions about the link. Default is *.)

If you use other DTMF codes, please enter the number of extra fields you need and press the "Show" button.
You will be able to chose from the following codes:
   

Other Notes or Information

Other: